Full screen segment signal jammer for EOD precautions

Full-screen signal jammers are mainly used in some special places where the Internet cannot be used, but some full-screen signal jammers will be used in military EOD missions, and they are used in the pursuit of criminal suspects and the defense of key leaders and transport teams Driving and other secret mission places. The shielded car is a complete set of system software, mainly including high-power DDS control module, microwave radio frequency omnidirectional antenna, coaxial cable, power supply system and other system components.

For the full-screen segment signal jammer, before the control module of the full-screen segment signal jammer is plugged in, the wireless antenna on the ceiling needs to be lifted up. The full-screen segment signal jammer uses an omnidirectional antenna. Only when the wireless antenna is vertical on the ground can it For best results.

Because the full-screen segment signal jammer uses power generation, in the case of high-speed driving, there is enough power to enable the entire device to normally open the interference. However, when the vehicle stops, it should be noted that the idle speed of the vehicle should be accelerated to ensure that there is sufficient power output to maintain the normal output of the interference vehicle's entire device control unit.

In order to prevent signal interference, the wireless antenna should be lowered when the car is not used for a long time. However, this is not necessary when using the vehicle under normal conditions. When it is not available for a long time, it is also necessary to charge the power compensation battery from time to time. When charging the battery, you only need to start the vehicle and turn on the power generation capacity.