Can the mobile phone signal blocker of the drag box type block while dragging?
The cell phone signal jammer, which is often referred to as a portable mobile phone signal jammer, such as our SMa-818T5B, which uses the American Pelican military standard tow box as the installation carrier of the mobile phone signal jammer, such as The appearance structure is convenient and portable. It is very convenient and quick to drag the mobile phone signal jammer like a suitcase.
Then the question came, and the customer asked us: Can the cell phone signal jammer of the drag box type be blocked while being dragged in the power-on state? Our answer is yes, of course it can be done, but in actual use, this behavior is less common. Why is this?
The original intention of the design of the mobile phone signal jammer is to facilitate the towing and transfer of the use site. Because of the weight of the signal shielding device and the large-capacity battery required for continuous work for a long time, the whole set of products The weight is not too light. When the mobile phone signal jammer of the tow box is in the open working state, the multiple omnidirectional antennas that are matched with it must be screwed on the antenna terminals on the upper end of the tow box. Because of the existence of the antenna and the weight of the signal shielding device, when shielding and dragging, the staff needs to prevent the antenna from being squeezed, which will make the force of the hand somewhat uncomfortable.
Therefore, in general, there is no problem with the towing box-type signal shielding equipment, as long as the staff pays attention to the protection of the antenna when dragging.
